Shed Pads in London, Ontario: Gravel Base, Permits and Setbacks
The best shed pad for most yards in London, Ontario is a compacted granular base: strip the sod and topsoil, lay geotextile, then build up compacted crushed gravel that is level and extends past the shed footprint. In London, a shed has to sit in the side or rear yard and follow the City's setbacks, and under the Ontario Building Code, small storage sheds are generally exempt from a building permit. Even so, confirm your shed's size and location with the City before you build.
Why the Base Matters More Than the Shed
Most shed problems in southwestern Ontario start at ground level. London's heavy clay soils hold water, and freeze-thaw cycles move anything sitting on wet ground. A poor base leads to:
Doors that stick or won't close as the frame twists out of square.
Rotting floor joists from sitting in wet soil or puddles.
Uneven settling that strains walls, roofs and windows.
Frost heave that lifts one corner in winter and drops it in spring.
A well-drained gravel pad solves most of these problems at once, because water drains down through the stone instead of collecting under the floor. Our post on frost heave in London, Ontario explains why saturated clay moves in winter.
Do You Need a Permit for a Shed in London?
There are two sets of rules: the Ontario Building Code (whether you need a permit) and London's Zoning By-law (where the shed can go).
Building Permit
Under the Ontario Building Code, a shed is generally exempt from a building permit when it meets all of these conditions:
It is 15 m² (about 161 sq ft) or less in gross area.
It is one storey.
It is detached from other buildings.
It is used only for storage.
It has no plumbing.
The City of Toronto's permit guidance explains this Ontario Building Code exemption clearly. Each municipality applies the code, so confirm with London's Building Division at 519-661-4555 before you buy a larger shed. Garages, workshops and pool houses are treated differently from storage sheds.
Zoning Rules in London
The City's common homeowner projects page lists the key zoning rules for accessory buildings:
Location: only in an interior side yard or rear yard, never in the front yard or exterior side yard.
Setbacks: at least 0.6 m (2 ft) from side and rear lot lines.
Small sheds: sheds under 10 m² are exempt from setbacks, but they must sit entirely in the rear yard and cannot overhang the property line.
Height: a maximum of 4 m from average finished grade. It can go higher, up to 6 m, if the building is moved back from the lot line by the extra height.
Lot coverage: all accessory structures together cannot exceed 10% of the lot area.
Zoning still applies even when no building permit is required. Outside London, in places such as Middlesex Centre, Thames Centre or Central Elgin, the local township's zoning by-law sets the rules.
Shed Base Options Compared
Here is how the common options compare for a typical backyard storage shed:
Compacted gravel pad: Drains well and tolerates frost movement. It is DIY-friendly for small sheds and easy to level. It is the best all-round choice for clay soils.
Concrete slab: Very durable and good for heavy equipment storage. It costs more, takes longer, and can crack if the base underneath isn't prepared properly.
Concrete deck blocks: Fast and inexpensive. They can shift in clay soil and leave the floor exposed to moisture if the ground isn't drained.
Pressure-treated skids on gravel: Common for prefab sheds. They work well when they sit on a compacted stone base rather than bare soil.
Paver pad: Looks finished and works for small sheds. It needs the same compacted granular base as a patio.
For most residential sheds in the London area, a gravel pad, alone or under treated skids, offers the best value and performance.
How to Build a Gravel Shed Pad: Step by Step
1. Lay Out the Pad
Mark an area at least 30 cm (1 ft) larger than the shed on every side. The extra width keeps rainwater from roof edges off the floor and gives you a stable place to step.
2. Call for Locates
Before you dig, request free utility locates through Ontario One Call. Gas, hydro, cable and irrigation lines often run through backyards.
3. Excavate
Remove the sod and all the topsoil. Organic soil compresses and rots, so it can't sit under a base. On clay lots, excavate 10–20 cm below the finished grade, deeper if the area is wet.
4. Lay Geotextile Fabric
Non-woven or woven landscape fabric keeps the clay from mixing into the gravel over time. This one step makes a big difference to how long the pad lasts.
5. Add Gravel in Lifts
Use crushed granular material, such as Granular A or 3/4" crusher run, and compact it in layers of about 5–10 cm with a plate compactor. Clear stone is another option where drainage is the main concern. You can browse options on our gravel page.
6. Level and Check
Finish with a screeded, level top. Check it with a long level or string line in both directions. The surrounding ground should slope away from the pad so that water drains off it.

How Much Gravel Do You Need?
Multiply the pad's length × width × depth (in metres) to get cubic metres, and add about 10–15% for compaction. For example, a 3.0 m × 3.6 m pad at 0.15 m deep needs about 1.6 m³ before compaction. Our material calculators do the math for you, and our guide to ordering topsoil, mulch or gravel in London explains how to convert to delivery volumes.
Shed Pad Checklist
Before the shed arrives, confirm the following:
The shed's size meets the permit exemption, or you have a permit.
The location is in the side or rear yard and meets setbacks.
Utility locates are complete.
Sod and topsoil are fully removed from the footprint.
Geotextile is down and the gravel is compacted in lifts.
The pad is level and at least 30 cm larger than the shed on every side.
The surrounding grade drains away from the pad.
There is a clear access route for delivery of the shed.
Can You Build a Shed Pad in November?
Yes, as long as the ground isn't frozen. Late fall works well in London: excavation is easier before frost, and a pad built now has the winter to settle before the shed goes up in spring. Don't place gravel on frozen or snow-covered soil. Once a deep frost sets in, it is better to wait.
FAQ
How big can a shed be without a permit in London, Ontario?
Under the Ontario Building Code, a detached, one-storey storage shed of 15 m² or less with no plumbing is generally exempt from a building permit. Confirm with London's Building Division at 519-661-4555, and keep in mind that zoning rules still apply.
How close to the property line can I put a shed in London?
The City's guidance is at least 0.6 m (2 ft) from side and rear lot lines. Sheds under 10 m² are exempt from setbacks but must be fully in the rear yard and cannot overhang the property line.
Is gravel or concrete better for a shed base?
For most storage sheds on clay soil, a compacted gravel base is better. It drains well, tolerates frost and costs less. Concrete makes sense for heavier loads or workshops, but it needs good base preparation to avoid cracking.
How deep should a gravel shed pad be?
On London's clay soils, 10–20 cm of compacted granular material over geotextile is typical, with more depth in wet areas. Always remove the topsoil first.
Can I put a shed directly on grass?
It's not recommended. Grass and topsoil hold moisture, rot and settle, so the floor will rot and the shed will go out of level. A gravel pad lasts far longer.
Need a Shed Pad Built?
SPM Landscape & Excavation has been preparing bases, pads and grading for London-area homeowners since 2006. We are WSIB covered with $1 million in liability insurance. Call (519) 474-0008 or email spmlandscape@gmail.com for a free quote. We are located at 791 Manchester Rd, London, ON.




Comments