top of page

Catch Basin Maintenance for Commercial Lots in London, Ontario

6 days ago
6 min read

Commercial catch basins in London, Ontario should be inspected and cleared of leaves, sediment and debris in late fall, then kept open through winter so meltwater can drain instead of refreezing on the lot. Private catch basins on a commercial property are the owner's to maintain, and anything that goes down them flows to the storm sewer system and, from there, to local creeks and the Thames River.


A blocked basin is not just a drainage problem. On a parking lot, standing water becomes black ice overnight, which raises slip-and-fall risk and drives up salt use. SPM Landscape & Excavation has maintained commercial properties and parking lots in London since 2006. This guide walks through what to check and when.


Why Catch Basins Matter in Winter


London winters swing above and below freezing many times. Each thaw sends meltwater across the pavement toward the lowest point, which is usually a catch basin. If that basin is plugged or buried under a snow pile, three things happen:


  • Water ponds around the grate and spreads across drive aisles and parking stalls.

  • Ponds refreeze at night into thick, smooth ice that is hard to treat.

  • Salt use goes up because crews have to keep re-treating the same wet areas.


Keeping basins working is one of the cheapest ways to cut winter risk on a commercial site.


What's Inside a Catch Basin


A typical parking lot catch basin is a concrete structure with a grate on top. Below the outlet pipe there is usually a sump, a space that lets sediment settle out before water leaves. Over time that sump fills with sand, grit, leaves and litter. Once it is full, sediment passes into the pipe and can block it, and the basin stops draining.


Some sites also have oil and grit separators or other stormwater controls tied into the system. These have their own maintenance needs and are often set out in site approvals, so check your property's documents.


Late-Fall Catch Basin Checklist


Run through this list before the first snowfall:


  • Walk the lot after a rain and note any ponding areas or slow-draining basins.

  • Clear leaves, litter and debris from every grate.

  • Check grates for damage, missing bolts or shifting frames.

  • Look for sunken or cracked asphalt around basin frames.

  • Lift a grate (safely, with the right tools) and check how much sediment is in the sump.

  • Book a vacuum truck cleanout if sediment is near the outlet pipe.

  • Confirm outlet pipes and downstream connections are flowing.

  • Mark basin locations with snow stakes so plow operators can avoid piling snow on them.


Keeping Basins Open Through Winter


Do not pile snow on catch basins


The single most common winter drainage mistake is pushing snow onto a basin. When it melts, the water has nowhere to go. A good snow site plan sets pile locations downslope of buildings and away from basins and walkways. Our guide to commercial snow site plans in London explains how to pick pile areas.


Clear grates before a thaw


When the forecast shows a thaw or rain on snow, have crews clear ice and slush off grates first. A few minutes per basin can prevent a lot-wide refreeze.


Watch for salt and sand build-up


Winter sand and grit wash into basins all season. Using salt and sand only where needed reduces what ends up in the sump. Our post on Smart About Salt certification covers best practices for application rates and record keeping.


Commercial parking lot full of parked cars

What Can and Can't Go Down a Storm Drain


The City of London is clear on this. Its sewers and wastewater page says only rain should go down the drain, because catch basins carry water untreated to local waterways. The City describes putting chemicals into storm sewers as illegal, and says latex paint and concrete wash water should never go into the storm system.


For commercial properties, that means:


  • No washing out concrete trucks, paint equipment or mop buckets into catch basins.

  • No dumping of oil, antifreeze or cleaning chemicals.

  • Spill kits on hand for vehicle leaks near basins.

  • Contractors briefed on the rules before work starts.


London's Wastewater and Stormwater By-law WM-28 governs what may be discharged to the City's sewer systems, and it defines stormwater infrastructure to include catch basins. If your site has an industrial or commercial use with special discharge concerns, read the by-law or speak with the City.


Fixing Chronic Ponding


If a basin works but water still ponds nearby, the problem is usually the pavement.


  1. Settled basin frames. The asphalt around the frame sinks below the grate, or the frame sits too high. Resetting the frame and patching fixes it.

  2. Low spots in the lot. Asphalt that has settled creates birdbaths. Milling and paving or overlay corrects the slope.

  3. Too few basins. Some older lots were built with drainage that no longer keeps up. Adding a basin or a trench drain at the problem area can help.

  4. Blocked pipes. If the basin itself fills and stays full, the outlet pipe or downstream system may be blocked and need flushing or a camera inspection.


For driveway and entrance areas, our article on trench drains explains when a linear drain makes sense.


Year-Round Maintenance Schedule


Use this as a starting point and adjust for your site:


  • Spring: sweep winter sand from the lot, then inspect and clean basins once the sand is gone.

  • Summer: check for damage after heavy storms and keep landscaping debris off grates.

  • Fall: clear leaves often, inspect sumps and book cleanouts before freeze-up.

  • Winter: keep grates clear, keep snow piles off basins and clear grates before thaws.


Sites with heavy traffic, lots of trees or large winter sand use may need more frequent cleanouts.


Safety When Inspecting Catch Basins


Catch basins look simple, but they are a confined space hazard and a trip hazard once the grate is off.


  • Never enter a catch basin. Inspections are done from the surface with a light, a measuring pole or a camera.

  • Use the right tool to lift grates. Grates are heavy. Use a grate hook or lifter, and lift with your legs.

  • Cone off the area. Keep cars and pedestrians away while a grate is open.

  • Replace grates right away. An open basin in a parking lot is a serious hazard, especially at night or under snow.

  • Leave cleanouts to vacuum trucks. Professional hydro-vac or vacuum services remove sediment safely and dispose of it properly.


Signs a Basin Needs Attention Now


Do not wait for the scheduled cleanout if you notice:


  • Water still sitting in or around the grate a day after rain

  • Sinkholes or cracks forming around the frame

  • Ice building up repeatedly in the same spot

  • Odours or oily sheens near the grate

  • Debris, sediment or garbage visible right at the grate


Who Is Responsible?


On private commercial property, the owner is responsible for private catch basins, pipes and other stormwater features on the site. Lease agreements often pass this to a tenant or property manager. If you are not sure, check your lease and site plan approvals before winter, not after a flood.


FAQ


How often should commercial catch basins be cleaned?


It depends on traffic, trees and winter sand use. Many sites inspect in spring and fall and clean whenever sediment builds up near the outlet pipe. Busy lots may need more frequent service.


Who maintains catch basins on a commercial parking lot?


The property owner maintains private catch basins on their site. Leases may assign this to a tenant or property manager, so check your agreement.


Can I wash concrete or paint tools into a catch basin?


No. The City of London says catch basins drain untreated to waterways and that latex paint and concrete wash water should never go into the storm sewer system.


Why does my parking lot ice over near the drains?


Usually because the basin is blocked, buried under snow, or the pavement around it has settled. Water ponds and refreezes. Clearing the grate and fixing the grade around the frame solves most cases.


Should snow be piled on catch basins?


No. Snow piled on a basin blocks meltwater and causes ponding and ice. Mark basins with stakes and keep piles away from them.


Get Help With Commercial Lot Drainage and Snow


SPM Landscape & Excavation offers commercial property maintenance, drainage repair and winter snow and ice services in London and area. Call (519) 474-0008 or email spmlandscape@gmail.com. We are WSIB covered and carry $1 million in liability insurance.


Comments


(519) 474-0008

©2022 by S.P.M Landscape

bottom of page