Foundation Backfill in London, Ontario: Preventing Settling
Backfill is the soil placed back against your foundation walls after they're built or repaired. All backfill settles somewhat, but it settles far less when it's clean material placed in layers after the walls are properly supported, then graded so water flows away from the house. When backfill is rushed, the ground beside the foundation sinks, water collects against the wall and basement leaks often follow.
This guide covers what good backfill looks like, the rules builders follow in Ontario, and how to fix a settled backfill zone around an older London home.
What Foundation Backfill Does
When a foundation is built, the excavation is dug wider than the walls so crews have room to work, install drainage and waterproof the outside. That extra space is called the over-dig. Once the walls are finished, the over-dig is filled back in.
Good backfill has four jobs:
Support the soil around the house without pushing too hard on the walls
Let water reach the foundation drain instead of pooling against the wall
Provide a stable base for walkways, steps, decks and landscaping
Create a surface that can be graded so rain and snowmelt run away from the building
The Basic Rules in Ontario
Builders follow the Ontario Building Code and local building department standards. Ontario municipalities publish standard details that summarize the key points. One example from the TACBOC standard detail for excavation and backfill says:
Backfill within 600 mm of foundation walls must be free of deleterious debris and boulders over 250 mm in diameter.
Foundation walls must be braced, or have the floor joists installed, before backfilling.
The site must be graded so surface, sump and roof drainage won't accumulate at or near the building and won't adversely affect neighbouring properties.
A builder's guide from the City of Markham on lateral support of foundation walls explains why bracing matters. Until the floor system ties into the top of the wall, a tall wall can be pushed inward by the weight of wet soil.
Your local building inspector has the final word. If you're adding onto a house, building a garage or replacing a foundation in London, Middlesex Centre or Thames Centre, confirm the requirements with your building department before backfilling.
Choosing Backfill Material
The best backfill drains well and compacts predictably. In London, a lot of the native soil is clay, which brings some challenges.
Clay
Clay holds water, swells when wet and shrinks when dry. Using wet clay right against a foundation wall can add pressure and slow drainage. Many builders still reuse native soil from the dig, but they keep debris and large stones out of the zone next to the wall and finish the top with soil that can be graded.
Granular material
Granular fill, such as sand or crushed stone, drains well and compacts with less settlement. It's often used around foundation drains, under steps and walkways, and where loads will sit right beside the house. See our gravel and aggregate products for common options.
Topsoil
Topsoil belongs on top, not as structural backfill. A final layer of good topsoil lets you shape the grade and grow grass or plants. Our topsoil page lists what we deliver.
What doesn't belong in backfill
Construction debris such as wood offcuts, drywall, packaging or concrete chunks
Large boulders that can crack a wall or create voids
Frozen soil, snow or ice, which leave voids as they melt
Organic material such as stumps and sod, which rot and settle

Placing Backfill the Right Way
How backfill goes in matters as much as what goes in. A careful crew will:
Confirm the walls are braced or the floor system is installed.
Check that waterproofing, drainage board and the foundation drain are in place and undamaged.
Cover the foundation drain with clean stone before the soil goes in.
Place backfill in layers rather than dumping it all at once.
Compact each layer with equipment sized for the job, staying back from the wall so it isn't damaged.
Leave the finished surface higher next to the house so it slopes away.
Re-check and top up the grade after the soil has had time to settle.
Dumping the whole over-dig full in one pass is quicker, but it traps air pockets that collapse over the following seasons. That's when you see a trench of sunken ground running around the house.
Why Backfill Settles Anyway
Even good backfill settles a little, especially in the first year or two. Rain, snowmelt and freeze-thaw cycles all consolidate soil over time. In southwestern Ontario, the freeze-thaw cycle is a big factor. Soil that freezes, thaws and refreezes moves, and loose backfill moves more. Our article on frost heave in London explains how frost lifts steps, decks and walkways.
Settlement becomes a problem when it changes the grade. If the ground next to the wall drops lower than the yard, water flows toward the house instead of away.
Signs Your Backfill Has Settled
Walk around your home after a heavy rain or during the spring thaw and look for:
A low strip or trench along the foundation where water sits
Downspout splash pads tipping toward the house
Gaps between the soil and the foundation wall
Walkways, steps or patio slabs sloping toward the house
Damp patches, efflorescence or leaks on the inside of basement walls at the same spots
How to Fix Settled Backfill
For minor settlement, the fix is usually regrading:
Remove sod, mulch or stone from the low area next to the house.
Add suitable fill and compact it in thin layers.
Shape a positive slope away from the foundation.
Cap with topsoil, then reseed, sod or mulch.
Extend downspouts so roof water is released well away from the wall.
Keep finished soil below siding and any wood framing. If adding soil would bury them, a swale, drain or other solution may be needed. Our guide to lot grading in London covers slopes, swales and the city's lot grading rules.
If there's a bigger problem, such as a cracked wall, a crushed foundation drain or a void under a walkway, the backfill may need to be dug out and replaced. That's a job for an excavation contractor, and possibly a foundation repair company or engineer.
Timing in Southwestern Ontario
Backfilling and regrading work best when the soil is workable, not saturated and not frozen. Late fall is often possible in London until the ground freezes, but frozen soil should never be used as backfill. If your project lands in the colder months, read what excavation work can still get done in late fall and winter.
FAQ
How long does foundation backfill take to settle?
Most settlement happens in the first year or two, as rain, snowmelt and freeze-thaw cycles consolidate the soil. Well-compacted backfill placed in layers settles much less than soil dumped in all at once.
Can I use clay as foundation backfill?
Native clay is often reused, but the zone next to the wall must be free of debris and large stones. Many builders use granular material around the foundation drain and under walkways, then finish with soil that can be graded away from the house.
Do foundation walls need to be braced before backfilling?
Yes, where the code requires lateral support. Ontario standard details state that foundation walls must be braced or have the floor joists installed before backfilling. Your building inspector will confirm what applies to your project.
How do I fix ground that has sunk next to my foundation?
For minor settlement, add suitable fill in thin, compacted layers, slope it away from the house and cap it with topsoil. Keep soil below siding and extend your downspouts. Larger voids or a damaged drain may require excavation.
Can backfilling be done in winter?
It can be done in cold weather if the backfill material is not frozen and the excavation is free of snow and ice. Frozen soil leaves voids as it thaws, so it should never be used as backfill.
Talk to SPM About Backfill and Grading
SPM Landscape & Excavation has handled excavation, backfill and grading around London and southwestern Ontario since 2006. We're WSIB covered and carry $1 million in liability insurance. Call (519) 474-0008 or email spmlandscape@gmail.com for a free quote.




Comments