top of page

Brine Anti-Icing for Commercial Lots in Ontario: How It Works

Oct 26
6 min read

Brine anti-icing means spraying a salt-and-water solution onto pavement before a storm. The brine dries into a thin layer that stops snow and ice from bonding to the surface, so plows clear the lot more completely and less salt is needed afterward. For Ontario commercial properties, it's one of the most effective ways to improve safety while cutting salt use.


Most commercial lots in London still rely on rock salt spread after the snow starts. This guide explains how anti-icing works, when it does and doesn't make sense, and what property managers should ask their snow contractor.


Anti-Icing vs. De-Icing


These two terms get mixed up, but they work differently:


  • De-icing is reactive. Salt is applied after snow or ice has already formed and bonded to the pavement. It takes more salt to break that bond.

  • Anti-icing is proactive. Liquid is applied before the storm, so a bond never forms. Snow sits on top of the brine layer and plows off cleanly.


The Sustainable Technologies Evaluation Program's salt application best practices brochure for winter maintenance contracts describes anti-icing as applying a liquid, such as salt brine, to pavement before a storm so snow and ice can't bond and less salt is needed after plowing.


How Brine Anti-Icing Works


  1. Brine is made. Salt is dissolved in water to a set concentration.

  2. The forecast is checked. Operators watch for a storm and check pavement temperatures.

  3. Brine is applied. A truck or sprayer applies brine in thin lines or a fan pattern across the lot, usually hours or even a day or two ahead of the storm.

  4. The water evaporates. A thin salt residue stays on the surface.

  5. Snow falls. The residue keeps the first layer of snow from bonding.

  6. Plows clear. Snow lifts off more easily, and less follow-up salt is needed.


Pre-Wetting: The Related Technique


Pre-wetting means coating rock salt with brine or another liquid as it's spread. Wet salt sticks to the pavement instead of bouncing into snowbanks, and it starts working faster.


The STEP brochure reports that in an Ontario study, pre-wetted salt outperformed dry salt in 5 of 7 cases, reducing snow cover by 18% to 40%. It also notes that a US study found closed-loop electronic spreader controllers saved up to 47% of salt compared with manual systems.


Brine, Rock Salt and Sand: Quick Comparison


  • Brine (anti-icing): Applied before a storm as a liquid. Prevents snow and ice from bonding. Works best with good timing and moderate pavement temperatures.

  • Rock salt (de-icing): Applied during or after a storm. Melts snow and ice that have already formed. Dry salt can bounce and scatter, so more product may be needed.

  • Pre-wetted salt: Rock salt coated with liquid as it's spread. Sticks better and starts working faster than dry salt.

  • Sand or grit: Adds traction but doesn't melt anything. It clogs drains, catch basins and permeable pavers, and it has to be swept up in spring.


Most good winter programs use a combination, matched to the weather and the site.


Why It Matters: Salt and the Environment


Environment and Climate Change Canada's road salts FAQ explains that almost all chloride from road salt ends up in waterways, through surface runoff or through soil and groundwater. In surface water, chloride can harm freshwater plants, fish and other organisms. Heavy use also damages roadside plants and soil organisms.


For property owners, there's a practical side too. Salt damages concrete, interlock, landscaping and vehicles, and it gets tracked into buildings. Our article on de-icing salt damage covers how to protect hardscapes and plants.


Streetlights illuminating a snowy parking lot at night

When Anti-Icing Works Best


Brine anti-icing is most effective when:


  • A storm is forecast and timing is predictable

  • Pavement temperatures are in the range where salt works well

  • The storm is expected to start as snow or freezing rain, not heavy rain

  • The lot can be treated before traffic packs the first snow down

  • The same areas need to be bare and safe early, such as entrances, walkways, ramps and accessible parking


When Anti-Icing Doesn't Make Sense


Brine isn't the answer for every storm:


  • Rain before snow: Heavy rain can wash the brine away before the snow arrives.

  • Very cold pavement: Ordinary salt brine loses effectiveness as temperatures drop. Other products or methods may be needed.

  • Blowing, drifting snow: Brine on a dry, cold, windy day can attract drifting snow.

  • Too much product: Applying too heavily can leave a slippery film. Calibrated equipment matters.


That's why anti-icing is a tool in a winter plan, not a replacement for plowing and targeted salting.


Common Mistakes With Anti-Icing


  • Spraying too far ahead. Traffic and weather wear the residue down if it's applied too early.

  • Ignoring pavement temperature. Air temperature isn't the same as pavement temperature, and the pavement is what matters.

  • Skipping calibration. Uncalibrated sprayers can apply too little to work or so much that the surface gets slick.

  • Treating everything the same. Entrances, ramps and walkways need more attention than far corners of the lot.

  • Not logging applications. An anti-icing visit that isn't recorded doesn't help you if there's a claim.


Anti-Icing Checklist for Property Managers


Use this when you review your winter maintenance contract:


  • Does the contractor offer anti-icing or pre-wetting?

  • Are operators trained and certified through the Smart About Salt program?

  • Are spreaders and sprayers calibrated?

  • Is application based on forecasts and pavement temperatures?

  • Are high-risk areas, such as entrances, ramps and accessible spaces, prioritized?

  • Are all plowing, salting and anti-icing visits logged with dates, times and materials?

  • Is the contract structured so the contractor isn't rewarded for over-salting?


Contracts, Records and Liability


The STEP brochure makes a few contract recommendations that are worth noting. It suggests requiring Smart About Salt training and certification for contractors and staff, using pricing structures such as a lump sum per season or a fixed fee per event that don't encourage overuse of salt, and requiring documentation of plowing and salting activity. It notes that accurate records of where, when and how plowing and salting happened are the best defence against lawsuits.


If you're comparing contract types, read seasonal vs. per-push snow contracts. For the legal timeline that applies to slip-and-fall claims, see the 60-day notice rule explained.


Does Anti-Icing Save Money?


It can, but it depends on your site. Anti-icing reduces the amount of salt needed after storms and can shorten clean-up time, but it adds visits before storms. The STEP brochure cites an example where Toronto's road salt training program for supervisors and operators cut salt use by almost 37,000 tonnes over two winters, saving nearly $1.9 million. Results on a single commercial lot will be smaller, but the principle is the same: better timing and less waste.


The best way to know whether it fits your property is to walk the site with your contractor and get a quote that compares approaches.


Planning for This Winter


Late October and November is the time to finalize winter plans in London. Use this window to:


  • Walk the site and mark high-risk areas

  • Confirm where snow will be stored. Our guide to commercial snow site plans can help

  • Review last year's logs and incidents

  • Confirm your contractor's equipment, certification and insurance


FAQ


What is brine anti-icing?


It's spraying a salt-and-water solution on pavement before a storm. The brine dries into a thin salt layer that stops snow and ice from bonding, so plows clear more completely and less salt is needed afterward.


Is anti-icing the same as pre-wetting?


No. Anti-icing is applying liquid to pavement before a storm. Pre-wetting is coating rock salt with liquid as it's spread, so it sticks and works faster.


Does brine anti-icing reduce salt use?


It can. Preventing the bond between snow and pavement means less salt is needed after plowing. An Ontario study cited by STEP found pre-wetted salt also outperformed dry salt in most cases.


When should brine not be used?


When heavy rain is expected before snow, during very cold pavement temperatures where ordinary salt brine is less effective, or in dry, windy conditions where it can attract drifting snow.


What is Smart About Salt certification?


It's an Ontario training and certification program for winter maintenance contractors and property staff focused on using salt effectively and responsibly. STEP recommends requiring it in winter maintenance contracts.


Talk to SPM About Commercial Winter Services


SPM Landscape & Excavation provides commercial snow and ice management across London and southwestern Ontario. We've been in business since 2006, we're WSIB covered and we carry $1 million in liability insurance. Call (519) 474-0008 or email spmlandscape@gmail.com to talk through your site.


Comments


(519) 474-0008

©2022 by S.P.M Landscape

bottom of page